Manual
8
LED off
: The logger is in normal data storage mode. The LED flashes in the recording interval you set up.
If the set interval is 10 seconds, the LED flashes every 10 seconds. If the set interval is 1 minute, the LED
will flash every minute.
LED flashes quickly
: There is a memory card error. One possible reason is that the memory card has
not been inserted correctly but it is also possible that the power consumption of the memory card is too
high to ensure proper recording.
Quick flashing can also indicate that the wind logger is ready for communication via the RS-232 interface.
LED on
: The logger is in setup mode and settings must be made by means of a computer connected to
the device via the RS-232 interface.
5.2
Setup of the wind logger PCE-WL2
5.2.1
Setup of the data on the SD card by means of the software (for beginners)
Remove the SD card from the data logger and connect it to a PC by means of a card reader.
Start the file lewl_setup.exe. The following window will open:
