Manual
9
After making all settings, click on the “Write setup file” button to save the settings. You can now remove
the SD card from the PC and insert it into the logger again. Data storage will start automatically. The
flashing LED in the set recording interval indicates that the wind logger works properly.
5.2.2
Setup by means of the terminal programme (for experts)
The PCE-WL2 data logger has an integrated menu which can easily be configured by means of a
terminal programme via a PC. All parameters (except date and time) are saved to the device permanently
and so not have to be set every time.
Note: PCs which are equipped with Windows 7 do not have an integrated terminal programme. As a
replacement, we recommend the programme HTerm by Tobias Hammer which is freely available.
5.2.2.1 Connection to a PC
In order to carry out the configuration of the device, open the terminal programme and connect the device
with the following parameters:
1. the COM port you use
2. baud rate: 4800
3. 8 data bits
4. no parity
5. 1 stop bit
6. no flow control
