© PCE Instruments
7
When the minimum load is present and the minimum time has elapsed, the actual measurement
begins.
“AVE..." appears on the display. The measurement is made. During this measurement, it
is not possible to see the current measured value.
When the measurement is completed, the display shows "DONE". You will then see the average
reading.
To reset the average value to start a new measurement, press the "Zero" key. The measured
value is saved at the same time. Up to 10 average values can be saved.
5.4
Save Mode
In "SAVE Mode", the highest measured values can be saved in a single measurement run. In the
memory, you can save 100 measured values (memory item number 00 ... 99). The number of
memory items used is displayed to the left of "SAVE". As soon as a single measurement run is
completed, the highest measurement value is automatically saved. It is recommended to
permanently save the measurement data on an external PC as the measurement values saved
in the meter could be lost.
You can set the minimum load for this function in the settings under "Save Load". This can be
found on the third menu page "OTHER SETTINGS".
