© PCE Instruments
4
6
Operation
6.1
Measurement preparation
•
Before using the device for the first time, insert the batteries correctly into the device
as described in chapter 7. The batteries are absolutely necessary to operate the
internal clock when the meter is switched off.
•
Insert an SD card into the card slot. Format the card before using it for the first time or
if the card has been formatted by other devices. To format the SD card, proceed as
described in chapter 6.7.1
•
Switch on the unit with the
"▼ / Power" key.
•
Check the date, time and sampling time (log interval).
Press the "▲ / Time" key for approx. 2 seconds. The set values are displayed one
after the other. You can change the date, time and sampling time as described in
6.7.2and 6.7.3
•
Make sure that the decimal character is set correctly. The default decimal character is
a dot. In Europe, however, the comma is customary. If the decimal character is not
set correctly in your country, this can lead to incorrect values and complications when
reading out the memory card. You can make the setting as described under chapter
6.7.5
•
Enable or disable the key and control sounds as described in chapter 6.7.4
•
Enable or disable the RS232 output described in chapter 6.7.6
•
Set the desired measurement range as described in chapter 6.8
•
Connect the signal line to the corresponding plugs of the measuring inputs, observing
correct polarity.
Attention!
Maximum input voltage 3000 mV. For higher voltages, a voltage divider must be
connected upstream!
