© PCE Instruments
9
6.6.7
Measurement range channel 1
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "tyPE CH1" appears on the display.
•
Use the
"▼" or "▲ / Time" keys to select the measurement range of the connected
pressure sensor.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; the meter will return to measuring mode automatically.
6.6.8
Measurement range channel 2
•
Procedure as in 6.6.7
6.6.9
Measurement range channel 3
•
Procedure as in 6.6.7
6.6.10
Unit of measurement
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "unit" appears on the display.
•
Use the
"▼" or "▲ / Time" keys to select the desired unit of measurement.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; the meter will return to measuring mode automatically.
Attention!
With the measurement range setting of 200 bar with the unit of measurement mmHg and with
the measurement range setting of 400 bar with the unit of measurement mmHg and inH2O, the
measured value must be multiplied by 100 when it reaches a certain level. A necessary
multiplication is signalled by synchronous flashing of the corresponding measured value and the
indication "x 100" at the lower edge of the display. (The measured values would be too long to
display).
7
Battery replacement
•
Replace the batteries when the low battery indicator
appears in the left corner of
the display or when "LobAt" is displayed. Low batteries can cause incorrect readings
and loss of data.
•
Loosen the middle screw in the lower area on the back of the unit.
•
Open the battery compartment.
•
Remove the used batteries and insert 6 new 1.5 V AAA batteries correctly.
•
Close the battery compartment and fasten the LOGking screw.
8
Reset system
If a serious system error occurs, resetting the system can solve the problem. To do this, press
the reset key with a thin object while the meter is switched on. Note that this resets the
advanced settings to the factory settings.
