Manual
4
4
Technical specifications
Display
LC display
Operation temperature
0 ... +60 °C
Voltage supply
3 x V CR2016 coin cell
Dimensions
320 x 130 x 25 mm
Weight
85 g
5
Instructions
5.1
Start-up operations
-
Attach the sensor to the extension.
-
Attach the extension to the handheld unit.
5.2
Switch on / off
-
Press the power button.
-
The device switches on and carries out a short self-test.
-
If you want to measure directly, press the power button again.
-
If the device is not in use, it switches off automatically after 30 seconds. Before switching off all
LEDs light up and the device starts to peep.
5.3
Measuring
-
Start the engine.
-
Insert the ignition cable into the sensor.
-
For obtaining best measurement results the minimum distance of the sensor to other metal parts
or cables should be 2.4cm (1 Inch). You should not touch the sensor during measurement.
-
At DIS vehicles the device could detect a doubling. For avoiding this effect please keep the
maximum distance between the engine and the measurement device.
-
If the measurement device restarts or changes measurement mode during a measurement, then
it could be possible that the ignition plug cannot ignite and the high voltage is nearly the same as
the output voltage of the coil.
