Manual
5
5.4
Quick Check mode
-
Simply switch on the device for entering the Quick Check Mode. You will arrive at this mode very
quickly.
-
The red and green LED will light up once a second until a spark is detected.
-
When a spark is detected then the upper red LED lights up. The two lower LEDs show the
polarity.
-
Using Quick Check Mode voltage only up to 5 kV can be measured.
6
Battery replacement
Open the back of the hand-held device and remove the old batteries. Then put two new 3V CR2016
Lithium batteries into the battery compartment and lock it.
7
Disposal
For the disposal of batteries, the 2006/66/EC
directive of the European Parliament applies. Due to the
contained pollutants, batteries must not be disposed of as household waste. They must be given to
collection points designed for that purpose.
In order to comply with the EU directive 2012/19/EU we take our devices back. We either re-use them or
give them to a recycling company which disposes of the devices in line with law.
If you have any questions, please contact PCE Instruments.
