© PCE Instruments
3
5
Preparation
•
Unpack the measuring device and check the scope of delivery.
•
Open the battery compartment on the back of the receiver and connect the battery,
observing correct polarity.
•
When closing the battery compartment, make sure it is properly locked.
•
Using a Phillips screwdriver, open the back of the transmitter and connect the battery,
observing correct polarity.
•
You can select the sound signal via the slide switch to the left of the battery:
1) Continuous tone
2) Pulsating sound
•
Close the transmitter again.
6
Operation
6.1
Sensor arm / Sensor
The sensor arm is of semi-rigid design and can be pre-bent according to the respective situation.
The sensor is located at the tip of the sensor arm under the black cap.
You will get the best search result if you can place the sensor at a 90° angle to the cable you are
looking for.
