© PCE Instruments
5
Press and hold down the measurement key on the receiver and follow the signal and thus the
cable with the sensor.
6.4
Short circuit / continuity test
Remove all loads from the circuit to be tested.
Slide the switch on the transmitter to the "CONT" position.
Test the function by connecting the red and black crocodile clips to each other. The green LED
should light up.
Continuity test
For the continuity test, connect the two ends of the conductor to be tested to one terminal each
of the transmitter. If the continuity resistance is <10 k
Ω, the green LED will light up.
Short circuit test
For the short circuit test, connect the crocodile clips to one of the conductors between which you
suspect a short circuit. When the green LED lights up, the short circuit is confirmed.
