© PCE Instruments
29
Eng
li
s
h
5
Operation
5.1
Start-up
To start up the device, press and hold the
Power
key for approx. 1.5 s. The device will display a
boot screen (fig. 3), followed by the home screen (fig. 4). The number of sensors displayed on
the home screen depends on the number of sensors enabled (fig. 4/5). The device will start up
with the sampling times set before turning off. At first start-up, the sampling times are 2 minutes
for all sensors but CO
2
the default sampling time of which is 10 minutes.
It is also recommended to set the time and date of the device (00:00 and 01/01/2021 as default
on start-up).
Fig. 38 Boot screen
Fig. 39 Home screen with all sensors enabled
Fig. 40 Home screen with three sensors enabled
Summary of Contents for PCE-AQD 50
Page 49: ...PCE Instruments...
