© PCE Instruments
4
3.8
Continuity test
In order to use the diode test function, follow the steps in chapter 3.6 and press the mode button
twice to switch to the continuity test function. If the resistance is lower than 150
Ω the device
gives out an acoustic signal.
3.9
Current measurement
To use the current measurement function, connect the test lead to the device. Next, turn the tip
of the device clockwise until the measuring tip comes out. Select the current measurement
function by using the function wheel. Use the mode button to select AC or DC measurement.
Now you can perform a current measurement.
3.10
Non-contact voltage test
The non-contact voltage test function can only be used on AC voltages. Use the function wheel
to select the non-contact voltage test. Now you can hold the tip of the device against the wire to
be tested. If the wire is live the red LED at the tip of the device will light up. The non-contact
voltage test can be performed at a distance of 3-4 cm.
