* If the Display show :
It means that the SD card is not plugged
SD CARD
into the meter.
EMPTY
5-2 Datalogger
a. Start the datalogger
Press the " Logger button ( 3-7, Fig. 1 ) > 2 seconds
continuously, until the Display show the indicator "
DATALOGGER ", release the " Logger Button " ( 3-7, Fig.
1 ), then the measuring data along the time information
will be saved into the memory circuit.
Remark :
*
How to set the sampling time, refer to Chapter 7-2,
page 15.
*
How to set the beeper sound is enable, refer to
Chapter 7-4, page 16.
b. Finish the Datalogger
During execute the Datalogger function ( Display show the
" Datalogger " indicator ), press the " Logger button " ( 3-7,
Fig. 1 ) > 2 seconds continuously, until the Display
indicator " DATALOGGER " is disappeared, release the
" Logger Button " will finish the Datalogger function.
Before take away the SD card from the
meter, it should execute the
procedures of " Finish the Datalogger ",
( It should wait for the Display counter to count
down to zero value. )
otherwise some existing recent save
data may loss.
11
