PCE Instruments PCE-VE 700, Instructions For Use Manual

2  Use

2.12  Conducting of Inspections

en

Instructions For Use  

LED BORESCOPE PCE-VE 700

  |  17 - Feb - 2016  |  Version: 0

Page 17 of 28

2.12

Conducting of Inspections

Conducting inspections
NOTICE!

 Sensitive optical, mechanical and electronic components. Damage

resulting from rough handling. Handle the device with appropriate care. Do not
bump or drop the product. Do not kink or pinch the probe; do not press the tip of
the probe against or past any immovable object.

Proceed as follows:

Selecting the probe

1. Choose a probe that is right for the purpose for which you intend to use it, and

which is suitable for the object you want to examine, and attach the probe to
the camera head.

Switching on the de-

vice

2. Switch the controller and the monitor on.

If you want to record the examination, then turn the PC that the probe is con-
nected to on and launch the documentation software.

Setting window sizes

3. Set the window size when you see the endoscopic image on the monitor (see

section 2.8

).

Focus the image

4. Bring the endoscopic image into focus (see 

section 2.9

).

White balance

5. Set the white balance (see 

section 2.10

)

Conducting inspections

6. Carefully insert the probe into the object you want to examine and begin your

inspection.

Regulate the LED light intensity by rotating the regulator on the controller.
If the image displayed on the screen appears too bright or too dark, then
optimize the image using the light intensifier on the computer screen (see

section 2.11

).

7. After conducting your inspection, carefully pull the probe out of the object with-

out tilting the probe.

8. Disconnect the probe from the camera head, place the protective cap back on

the head and close the lock.

Cleaning the probe

9. Clean the probe with a soft cloth. If necessary, use a mild cleaning solution

(see 

section 3.3

).

10. Switch off the devices.

Completed!