2
Bill of Materials
RDS MAX V1.0
Qty Value
Reference
Checklist (
√
)
1 NE5532P
IC1
1 MC1310P
IC2
1 4017
IC3
1 4046
IC4
1 TDA7330D
IC5
1 4066
IC6
1 4030
SMD
IC7
1 4013
SMD
IC8
1
90S2313 - 10
IC9
1
24C64 (24C32) ATMEL
IC10
1 78L05
IC11
1
78L09 or 78L10
IC12
1 CNY17
IC13
2
RCA connector for PCB
J1, J2
1
DB9F connector, PCB, 90 degrees
J3
1
Pilot input, optional
J4
1
Auto/manual pilot input selection, optional
J5
1 4.332
MHz
Q1
1 9.8304
MHz
Q2
1
LED Green (+681 resistor under the pcb)
D1
1
LED RED – Pilot lock to stereo encoder
D2
1 Wire
bridge
D3
1 75
Metal
R1
4
6K8 Metal
R2, R3, R6, R9
6
10K
R4, R5, R13, R16, R19, R20
1 15K
Metal
R7
2 33
R8,
R12
5
1K
R10, R11, R15, R22, R23
2
1K SMD under the 24C64
1 330K
R14
1 330
R17
1 2M2
R18
1
1K, special placement
R21
1 10K
trimmer
P1
1 15pF
C1
6
68-150nF
C2, C4, C5, C9, C11, C15
4
10uF
C3, C6, C7, C20
2 680pF
C12,
C32
1 1nF
C19
1 1uF
(yellow)
C16
9
47-100nF
C8, C13, C14, C17, C18, C21,
C22, C26, C31
4
22pF
C23, C24, C28, C29
2 10nF
C10,
C25
1
DIL 20 socket for IC9
1
DIL8 socket for IC10
1 PCB
Limitation of liability
To the maximum extent permitted by applicable law, in no event shall PCS Electronics or its suppliers be liable for any special, incidental,
indirect, or consequential damages whatsoever (including, without limitation, damages for loss of business profits, business interruption, loss of
business information, or any other pecuniary loss) arising out of the use of or inability to use the PRODUCT, even if PCS Electronics has been
advised of the possibility of such damages. In any case, PCS Electronics’ entire liability under any provision of this agreement shall be limited to
the greater of the amount actually paid by you for the PRODUCT or U.S. $5.00; because some states and jurisdictions do not allow the exclusion
or limitation of liability, the above limitation may not apply to you.
LEGAL INFO
It may be illegal to operate this device in your county. Please consult local authorities before using RDS MAX V1.0!
WARNING
Please note that there is high voltage present inside the RDS encoder (the version in enclosure with mains power supply). Do not touch
any of the exposed circuits or parts once the unit has been connected to the mains voltage. Failure to follow this might result in serious
injury or even death. Always unplug the mains cable before opening this unit and tampering inside the unit!
