Quick Start Guide
Keypad Products
KPT4, DKT4
©2012 Powerline Control Systems, Inc.
All Rights Reserved v2.01
19201 Parthenia St. Suite J
Northridge, CA 91324
P: 818.701.9831 F: 818.701.1506
pcssales@pcslighting.com
www.pcslighting.com
WIRING DIAGRAM
Status LED Indicator
The Keypads are each equipped with a bi-color Status LED, in
the upper right hand corner that is normally lit to red. This LED
indicator will flash different colors to indicate configuration
status as outlined below:
LED Color
Status
Solid RED
Power applied to Wall Switch
Flashes GREEN
Device is in LINK MODE
Solid GREEN
Transmitting a SPC™ message
To Factory Default the KP Series
Step
Status
1
On the Keypad; Press and hold the program
button (lower right hand corner) for 6 seconds.
The Status LED will flash GREEN
2
Tap the program button ten times to set its
defaults.
3
The device will indicate that its defaults were
set by blinking its Indicator LED ten times RED.
CERTIFICATION
This product has been thoroughly tested by
Intertek Testing Services, a nationally
recognized independent third-party
laboratory. The North American ETL Listed
mark signifies that the product has been
tested to and has met the requirements of a
widely recognized consensus of US and Canadian product safety
standards, that the manufacturing site has been audited, and that
the manufacturer has agreed to a program of quarterly factory
follow-up inspections to verify continued conformance.
LIMITED WARRANTY
Seller warrants this product, if used in accordance with all
applicable instructions, to be free from original defects in materials
and workmanship for a period of five years from the date of
purchase. Refer to the warranty information on the PCS website
(www.pcslighting.com) for exact details.
KPT4
DKT4
Neutral
Line
Ground
Neutral
Line
Ground
Figure 3
