Equipment Location
Spa Installation
After the hot tub has been placed in the desired
location remove a cabinet access panel using a phillips head
screwdriver. (See illustration )
Next, pull away the cabinet panel and locate the
electrical box, heater, pump (or pumps), air blower. Be sure
you have allowed ample space around the necessary cabinet
sides to access equipment. Review your spa model specification
page in this manual for a guide of equipment location for that
specific spa model.
For AdvantagePack Design spas:
Note the location of the electrical box, this will
need to be accessed to complete the wiring connection to the
home power source. For AdvantagePack design units, this is
located beneath the end cabinet with other support compo-
nents. Photo to the right features the XM platform. Note
that the XE platform used on the SE Series spas. Refer to the
spa specification page to identify the correct platform for
your spa unit.
Check that all valves: two per pump, are open and the
locking clip has remained snapped on the valve stem during
shipment. (See illustration )
The spa equipment has been assembled with numerous
collars (unions) for ease of future servicing. Locate and hand
tighten all collars checking for any that may have loosened
during shipment. (See illustration)
Refer to Spa Specification pages in this manual for the location of equipment for the model you
have chosen. installation and wiring is to be completed by a qualified electrician.
•
THE SPA SUPPORT EQUIPMENT MUST BE PLACED AT OR BELOW THE WATER LEVEL OF THE SPA.
•
NEVER PLACE THE EQUIPMENT ABOVE THE SPA WATER LEVEL.
•
ALL PDC EQUIPMENT MUST BE IN A SHELTERED ENVIRONMENT THAT WILL PROTECT THE
EQUIPMENT FROM RAIN, SLEET, SNOW, AND DIRECT SUNLIGHT.
24
Summary of Contents for Aruba LX
Page 1: ...1 800 451 1420 www pdcspas com Owners Manual revised 02 2016...
Page 2: ......
Page 51: ......
