Operation Systems
Summit™ Series | SX-SmartTouch™ Control
59
Page Up / Down
If an Up or Down button is shown and pressed when on a page with a text list, the list can
be scrolled a page at a time.
Overview
Pumps
On the Spa Screen, select a “Jets” button once to turn the pump on or off, and to shift between low- and high-speeds if equipped. If
left running, the pump will turn off after a time-out period. The low-speed of pump 1 runs when the blower or any other pump is
on. If the spa is in Ready Mode, Pump 1 low may also activate for at least 1 minute every 30 minutes to detect the spa temperature
(polling) and then to heat to the set temperature if needed. When the low-speed turns on automatically, it cannot be deactivated
from the panel, however the high speed may be started.
Filtration and Ozone
Pump 1 low and the ozone generator will run during filtration. The system is factory-programmed with one filter cycle that will run
in the evening (assuming the time-of-day is properly set) when energy rates are often lower. The filter time and duration are
programmable.
A second filter cycle can be enabled as needed.
At the start of each filter cycle, the water devices like blower and other pumps will run briefly to purge the plumbing to maintain
good water quality.
Clean-Up Cycle
When a pump is turned on by a button press, a clean-up cycle begins 30 minutes after the pump is turned off or times out. The
pump and the ozone generator will run for 30 minutes or more, depending on the system. On some systems, you can change this
setting.
Freeze Protection
If the temperature sensors within the heater detect a low enough temperature, then the water devices automatically activate to
provide freeze protection. The water devices will run either continuously or periodically depending on conditions.
In colder climates, an optional freeze sensor may be added to protect against freeze conditions that may not be sensed by the
standard sensors. Auxiliary freeze sensor protection acts similarly except with the temperature thresholds determined by the
switch. See your dealer for details.
Utilities Screen
Utilities
The Utilities Icon on the Settings Screen takes you
to the Utilities Screen.
Panel
Touching the Panel Icon you to the Panel Screen,
where you can set how long it takes the panel to
go to sleep after the last activity. The Sleep Timer
can be set from 1 to 60 minutes. The default is
30 minutes.
Summary of Contents for Summit SX15
Page 2: ......
Page 75: ...Operation Systems WAVE Wireless Control option 72...
