Regular Maintenance
80
Thermal Cover Care
Always use the locking thermal cover when not in use to reduce heat-up time, operating costs and keep unwanted out. To
prolong the life of the cover, handle it with care and clean it regularly using mild soap and water. Periodic treatments with a vinyl
conditioner will help protect against deterioration caused by UV rays from the sun. Never allow anyone to stand or sit on the cover,
and avoid dragging it across rough surfaces. Be sure to lock all straps when not in use for safety and to prevent wind damage. Keep
cover open at least 15 minutes after adding chemicals.
Access the web for further details on proper care and maintenance, replacement and use of the cover.
EverPure2™ Ozone and UV Care
The ozone hose and check valve connection between the ozone generator and ozone injector should be inspected or replaced, if
necessary, annually. The air quality pulled into the generator may cause rapid wear on the hose and check valve. The EverLite2™
will light green when the ozone generator is operating (during the filtration cycle) indicating the EverPure2™ system is indeed
sanitizing the water.
The UV-C bulb is estimated to be operative for about 1000 hours of use. Access the website for further information on proper
operation and replacement of this system.
Plumbing Care
Swim spas are plumbed with plastic jets, pipes and fittings which are glued together. These plastic parts and their many glue
joints are subjected to harsh treatment with years of operation, subjected to many hot-cold cycles and the high pressure
generated by the powerful jet pump stressing pipes and joints. Although the factory has a rigorous testing procedure, even
transportation from the factory to you can cause vibration and possible loosening of the joints.
Should a leak occur, remove that appropriate section of cabinet wall exposing the leaking area. Drain the swim spa to below the
leak and contact a qualified technician for repair.
Filter Cartridge Care
Swim Spa water filtration begins as soon as the flow is steady through the pump. As the filter cartridge removes dirt from the water,
the accumulated debris will cause a resistance to flow. When this is noticed, along with cloudy water, clean or replace the filter
element as noted below. This generally occurs monthly depending upon use and water care.
Pristine™ System:
Suction-side design
1. Shut off power at the main or sub panel.
2. Remove the filter housing top by pulling up the raised portions of the filter top.
3. Lift the skimmer basket out of the filter canister.
4. Remove the filter from the canister.
5. Replace with clean filter, either a clean spare which is recommended, or cleaning of the soiled removed cartridge. Refer to
scheduled care section for recommendations.
6. Place skimmer basket back in filter canister.
7. Place filter top onto filter canister and turn clockwise until top stops.
Swim Spa Acrylic Surface Care
To preserve the sheen of the acrylic surface, clean and sanitize with clean water to remove any particles and use rubbing alcohol
or a non-abrasive, non-sudsing cleaner to wipe clean. Use a soft, lint free cloth and never use an aggressive solvent such as a
lacquer thinner or acetone which will cause damage to the acrylic.
Summary of Contents for Summit SX15
Page 2: ......
Page 75: ...Operation Systems WAVE Wireless Control option 72...
