Better Solutions Are Within Reach
®
MODEL NUMBER:
PDI-CEILING-MT
Document Number:
PD196-016R5
Ceiling Mount
Page 2 of 2
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
ADJUST HEIGHT AND DRILL INNER TUBE
3. Slide the inner tube PDI-591 up to the desired height (see note “A”). Push the plastic sleeve
PDI-590 until the shoulder is seated in the outer tube. At the cross hole near the bottom of
the outer tube, drill through the plastic sleeve and the inner tube from each side. Use a 3/8”
diameter drill bit. Slide the 3/8” x 2-1/2” bolt through and tighten nut. Cut hole for tube in
ceiling tile and replace tile.
4. Drop a fish wire through the cable exit hole located near the base plate of the outer tube.
(not shown). The wire should exit the bottom of the tube. Remove the four ¼-20 socket
head bolts from the swivel collar PDI-589. Attach the fish wire to the cable pigtail(s) that exit
the arm swivel cap elbow. Being sure to first thread the cable(s) through the plastic shim
washer PDI-586.
ATTACH THE ARM SECTION
5. Pull the fish wire through the tube until the cables exit the base plate hole. Hold the plastic
shim washer PDI-586 against the bottom of the inner tube PDI-591. Be sure it does not
overlap the swivel collar. Hold the arm assembly against the bottom of the inner tube.
Thread locking compound LOCTITE® #242 (Blue) must be used on the ¼-20 socket head
bolts. Slide the ¼-20 socket head bolts through the swivel cap PDI-588 and thread back into
the swivel collar PDI-589. Tighten the ¼-20 socket head bolts to a torque of 10 ft-lbs.
END OF INSTRUCTIONS
