Document Number PD196-253R2
PDI-E24”, E29”, E32”, E42” LED TV User Manual
Page 24 of 29
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
System
Diagnostics
This is a display menu that provides readout of the TV’s internal
operations and version numbers.
Reset to Factory Defaults
This menu will allow you to reset the television to the factory default
settings. After choosing this function, you will reach a confirmation
screen. Press ►to begin reset process.
Standby Power
Low and Normal. Low will use less power in standby but will require
several additional seconds to turn on.
USB Cloning and FW Update
See Cloning Section Below
RF Cloning and FW Update
Allows programming and firmware updates to be sent to the TV over the coaxial antenna input. This requires
special equipment. Contact PDi for more information.
Support
PDi COMMUNICATION SYSTEMS, Inc.
40 Greenwood Lane, Springboro, Ohio 45066
800-628-9870
Cloning
Cloning allows quick programming of a TV from a USB Flash Drive.
The operation involves first downloading setup information from a
programmed host TV to a USB Flash Drive and then uploading the
setup information to another TV. Cloning can also be used to re-
program a programmed TV.
NOTE:
For cloning operation, the “USB Media” source must be
disabled
, otherwise the Media menu appears instead of the desired
Clone menu when using a blank USB drive.
*To exit cloning menu, you must remove the thumb drive.
Restore Setting to TV
1. Turn the TV On.
2. Insert a Flash Drive (user provided) into the USB Clone Port
located adjacent the Cable TV Jack.
3. When the Cloning Main Menu appears, p
ress CH▲ or CH▼ to
highlight Restore Setting to TV.
4.
Press VOL► to initiate.
5. When the Restore Settings to TV menu appears, press
CH▲ or
CH▼ to highlight the appropriate settings file.
6.
Press VOL► to initiate.
7. Wait for the Cloning Main Menu to reappear. You will get a
confirmation screen. Pr
ess ▲ to continue or ◄ to go back.
8. The TV will restart after settings are restored.
9. Remove the USB Disk from the TV.
10. Verify correct setup of the TV.
