WaveStar Static Transfer Switch 2000A 3-Pole
52
Ctrl Nr: PM375118-004
8
System Setup: Administration
This chapter describes administrative setup.
8.1
Administrative Access Level
Anyone can view the different display screens, but a login is required to use controls or make changes to
parameters.
The STS has four access levels:
1.
PDI:
This level has authorization for all actions except clearing the Event Log. PDI access is required
to use the Configuration screen.
2.
Service:
This access level is for PDI-authorized service representatives. This level has authorization
for all actions except clearing the Event Log.
3.
Administrator:
This access level has authorization for all actions and screens except Configuration
Screen, which is not available to users.
NOTE:
The Administrator is the only user who can clear the
Event Log
!
4.
Operator:
An operator can only change the
Preferred Source
.
8.2
Initial Administrator Access
STS security is based on the identification of each user by a PIN with an associated password. The PIN identifies
the user and the password allows access. This scheme also provides a login history and accurate forensics if
there is problem with the STS.
To initially set up STS users, PDI provides a temporary Administrator PIN and password. The administrator
should:
1. Log in on the
Home
screen in the
Operator
panel.
2. Navigate to the
Users
screen
3. Change the administrator PIN and password and then keep them secure.
4.
Set up each user’s security information as described in the following sections.
After initial startup, commissioning, testing, or restart, the administrator should clear any alarms that occurred.
8.3
Users Screen
•
Touch the
User
button at the bottom of a display screen to display the
Users
Screen (Figure 20).
•
The
Users
screen:
•
Lets the Administrator set up new users and their level of access to the switch.
•
Displays the names of registered users and unassigned slots.
•
Scroll through the User list using the scroll bar on the right side of the screen to highlight a user name or
number.
•
Set up or modify a user’s profile using the
Name
,
PIN
,
Password,
and
Class
buttons. Each user must be
assigned a Password and PIN.
