2. Connect
Before APP Bluetooth connects to the motor, please make sure that the
controller is turned off. And make sure that the APP is not running in the
background. The specific connection steps are as follows:
- If you need to connect multiple Bluetooth motors, repeat steps 3 and 4.
- Step 6: Automatically calibrating the lens stroke can also be replaced by manually
calibrating the lens stroke for calibration.
- For more about APP functions, please enter the APP SET interface and enter the HELP
item to view more detailed graphic tutorials.
1. Turn on the bluetooth
of the mobile phone and
start the APP
2. Click to enter the Bluetooth
selection interface
4. Select the displayed
bluetooth of the motor
to rename it
5. Click the connecticon, then
click CONTINUE enters the
main interface of the APP
6. Long press the AUTO
frame to automatically
calibrate the lens
7. Tap the "-" icon in the
control frame select the
motor to be controlled
8. Complete the settings,
slide the control bar to check
the motor can be controlled
normally
3. Insert the battery into the
motor and start the motor
When the controller replaces the battery, you need to pull up the shell
to see the battery compartment. Before pulling out the shell, first fix the
controller to any object with 1/4 screw hole by 1/4 screw. Then pull up the
casing forcefully and use a small wrench to push out the battery.
Unless you encounter force majeure factors such as battery damage
and drastically reduced battery life, it is not recommended to replace the
controller battery frequently. When replacing the battery, please check
whether the positive and negative directions of the battery are correct, and
then insert the battery.
1. Pull up the shell
forcefully
2. Use a small wrench
to push out the battery
Battery replacement instructions
