Trace Configuration
QT
RACE
-
U
SER
M
ANUAL
© 2018 PDQLogic Ltd.
QTrace User Manual Rev 1.01
Page 35
Figure 40 shows the trace configuration dialog populated with settings for one of the projects supplied
with the STM32-Eval board, a demonstrator for the QTrace system (see Appendix B STM32-Eval
Demonstrator).
Figure 40 Trace configuration for the STM32-Eval demonstrator project
Each entry in the trace configuration dialog is described in more detail in the following sections.
6.1.1
Manufacturer
This is a drop-down list of the supported device manufacturers. Currently ST Microelectronics is
supported but this will be updated in subsequent QTrace Analyser releases. There is a ‘Generic’ option
to allow devices that aren’t currently supported by the QTrace Analyser to be trialled.
Each manufacturer entry corresponds to a device definition file which is located at:
C:\Users\Public\PDQLogic\QTraceAnalyser\Devices
6.1.2
Part/Family
This is a drop-down list of the supported devices for the selected manufacturer. Currently, the QTrace
Analyser supports the STM32 F2/F3/F4/L4 devices. Each entry in the drop-down list may be a specific
device or a range of devices. This is dictated by the device feature set and the interrupt vector sources.
The interrupt source information is used by the profiling view, see section 5 on page 31.
6.1.3
ROM start address
This is the start of the program ROM (FLASH) in the target address space. It is a fixed address that is
specified by the manufacturer and is pre-populated. It cannot be edited except when the selected
manufacturer is ‘Generic’.