IMPORTANT
!!
ALL
EQUIPMENT
MODELS
ARE
120/240
VOLT,
60
CYCLE
FOR
STATE
‐
SIDE,
U.S.
INSTALLATIONS,
AND
50
HZ
FOR
EXPORT,
CE,
INSTALLATIONS.
All swim spas must be permanently connected.
All swim spa support systems are mul ple supply circuits.
All swim spa systems require the installa on of a ground fault circuit interrupter (GFCI) protector or equivalent;
(RCD, for export installs), at the power source (NOT SUPPLIED BY PDC SPAS) by a quali
fi
ed electrician in
accordance with all codes and regula ons. Refer to typical GFCI installa on photos and illustra ons on the
following
pages.
Prior to each use, tes ng of the GFCI (or equivalent RCD) is required! Refer to the maintenance sec on of this
manual for instruc ons
All swim spa support equipment must be bonded (grounded) to the pressure connector located within the
control support box as well as the outside of the control support box.
(see
wiring
schema c
below
and
references
on
following
pages)
Disconnect all electrical supplies and contact a quali
fi
ed technician before servicing.
All swim spa installa ons are to be performed by a licensed electrician and in accordance with all local and
na onal codes.
Swim
Fitness
Spa
Wiring
Schema c
for
Cer
fi
ed
Electricians’
Reference
Only
Wire “A”
Wire “B” *
O
1
Main Panel
Circuit Breaker
G.F.C.I.
Swim Spa
Disconnect
Wire “A”
Wire “B” *
Op on
2
Main Panel
Circuit Breaker
Swim Spa
D
G.F.C.I.
* Na onal U.S. code recommends distance not to exceed 15 .
Wiring Guidelines
32
ELECTRICAL
REQUIREMENTS
HAVE YOUR ELECTRICIAN READ THE FOLLOWING INFORMATION BEFORE INSTALLATION BEGINS.
Electrical connec ons made improperly, or the use of wire gauge sizes for incurring power which are too small, may
con nually blow fuses in the electrical equipment support box, may damage the internal electrical controls and
components, may be unsafe and in any case will void the swim
fi
tness spa warranty.
It is the responsibility of the swim spa owner to ensure that electrical connec ons are made by a quali
fi
ed electrician
in accordance with the Na onal Electrical Code and any local and state electrical codes in force at the me of installa on.
