Opera on Systems
Summit™ Series | SX
‐
SmartTouch™ Control
55
Se ngs
Screen
Heat
Mode—Ready
vs.
Rest
In order for the swim spa to heat, a pump needs to circulate water through the heater. The pump that performs this func on is
known as the “heater pump.”
The heater pump is a 2
‐
Speed Pump 1, Ready Mode will circulate water every 1/2 hour, using Pump 1 Low, in order to maintain a
constant water temperature, heat as needed, and refresh the temperature display. This is known as “polling.”
Rest Mode will only allow hea ng during programmed
fi
lter cycles. Since polling does not occur, the temperature display may not
show a current temperature un l the heater pump has been running for a minute or two.
When the heater pump has come on automa cally (for example for hea ng) you can switch between low speed and high speed but
you cannot turn the heater pump o
ff
.
Ready
‐
in
‐
Rest
Mode
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1 Bu on is pressed. When the heater pump has
come on automa cally (for example for hea ng) you can switch between low speed and high speed but you cannot turn the
heater pump o
ff
. A er 1 hour, the System will revert to Rest Mode. This mode can also be reset by selec ng the Heat Mode line.
Se ngs
Programming,
Etc.
The Se ngs Screen is where all programming and other spa behaviors are controlled.
Each icon on the Se ngs screen takes you to a di
ff
erent screen, where one or more se ng may be viewed and/or edited.
The Heat Icon
takes you to a screen where you control the Heat Mode and the Temperature Range.
Dual
Temperature
Ranges
(High
vs.
Low)
This system incorporates two temperature range se ngs with independent set temperatures. The speci
fi
c range can be selected on
the Se ngs screen and is visible on the Main Screen in the upper le corner of the display.
These ranges can be used for various reasons, with a common use being a “ready to use” se ng vs. a “vaca on” se ng. Each range
maintains its own set temperature as programmed by the user. This way, when a range is chosen, the spa will heat to the set
temperature associated with that range.
High Range can be set between 80°F and 104°F. Low Range can be set between 50°F and 99°F. More specific Temp Ranges may be
determined by the Manufacturer. Freeze Protection is active in either range.
