Opera on Systems
Summit™ Series | SX
‐
SmartTouch™ Control
60
Fault
Log
The Fault Log is a record of the last 24 faults that can be reviewed by a service tech. Use the Up and Down bu ons to view each of
the Faults. When Priming Mode shows in the Fault Log, it is not a fault. Rather, it is used to keep track of spa restarts.
GFCI
Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installa on.
CE registered systems do not have an RCD Test Feature due to the nature of the electrical service. The end
‐
user must be trained
how to properly test and reset the RCD.
It
is
mandatory
to
verify
proper
installa on
and
func on
of
the
GFCI
or
RCD.
Users
/
owners
are
to
manually
test
this
safety
device
prior
to
each
use.
Should
the
device
not
func on
properly,
shut
the
hot
tub
o
ff
at
the
breaker
and
contact
service
tech.
Units
Screen
The Units Icon
on the Se ngs Screen takes you to the Units Screen.
1. Press “Temp Display” to change the temperature between Fahrenheit and Celsius.
2. Press “Time Display“ to change the clock between 12 hr and 24 hr display.
Reminders
The Reminder Icon
on the Se ngs Screen takes you to the Reminders screen. Press
“Reminders“ to turn the reminder messages (like “Clean Filter”) ON (Yes) or OFF (No).
Clean
‐
Up
Cycle
Cleanup Cycle Dura on is not always enabled, so it may not appear. When it is available,
set the length of me Pump 1 will run a er each use. 0
‐
4 hours are available. Se ngs it to
0.0 Hr keeps the Cleanup Cycles from running.
The Cleanup Icon
on the Se ngs Screen takes you to the Cleanup Cycle screen.
Language
The Language Icon
on the Se ngs Screen takes you to the Language screen. Change
the language displayed on the panel.
Reset
Bu on
Only use the Reset Bu on prior to moving the spa to a new loca on.
Pressing the Reset the bu on forces a new Test to be performed at the new loca on.
