Regular Maintenance
80
Thermal
Cover
Care
Always use the locking thermal cover when not in use to reduce heat
‐
up me, opera ng costs and keep unwanted out. To
prolong the life of the cover, handle it with care and clean it regularly using mild soap and water. Periodic treatments with a vinyl
condi oner will help protect against deteriora on caused by UV rays from the sun. Never allow anyone to stand or sit on the cover,
and avoid dragging it across rough surfaces. Be sure to lock all straps when not in use for safety and to prevent wind damage. Keep
cover open at least 15 minutes a er adding chemicals.
Access the web for further details on proper care and maintenance, replacement and use of the cover.
EverPure2™
Ozone
and
UV
Care
The ozone hose and check valve connec on between the ozone generator and ozone injector should be inspected or replaced, if
necessary, annually. The air quality pulled into the generator may cause rapid wear on the hose and check valve. The EverLite2™
will light green when the ozone generator is opera ng (during the
fi
ltra on cycle) indica ng the EverPure2™ system is indeed
sani zing the water.
The
UV
‐
C bulb is es mated to be opera ve for about 1000 hours of use. Access the website for further informa on on proper
opera on and replacement of this system.
Plumbing
Care
Swim spas are plumbed with plas c jets, pipes and
fi
ngs which are glued together. These plas c parts and their many glue
joints are subjected to harsh treatment with years of opera on, subjected to many hot
‐
cold cycles and the high pressure
generated by the powerful jet pump stressing pipes and joints. Although the factory has a rigorous tes ng procedure, even
transporta on from the factory to you can cause vibra on and possible loosening of the joints.
Should a leak occur, remove that appropriate sec on of cabinet wall exposing the leaking area. Drain the swim spa to below the
leak and contact a quali
fi
ed technician for repair.
Filter
Cartridge
Care
Swim Spa water
fi
ltra on begins as soon as the
fl
ow is steady through the pump. As the
fi
lter cartridge removes dirt from the water,
the accumulated debris will cause a resistance to
fl
ow. When this is no ced, along with cloudy water, clean or replace the
fi
lter
element as noted below. This generally occurs monthly depending upon use and water care.
Pris ne™
System:
Suc on
‐
side design
1. Shut o
ff
power at the main or sub panel.
2.
Remove
the
fi
lter housing top by pulling up the raised por ons of the
fi
lter top.
3.
Li the skimmer basket out of the
fi
lter canister.
4.
Remove
the
fi
lter from the canister.
5. Replace with clean
fi
lter, either a clean spare which is recommended, or cleaning of the soiled removed cartridge. Refer to
scheduled
care
sec on for recommenda ons.
6. Place skimmer basket back in
fi
lter canister.
7.
Place
fi
lter top onto
fi
lter canister and turn clockwise un l top stops.
Swim
Spa
Acrylic
Surface
Care
To preserve the sheen of the acrylic surface, clean and sani ze with clean water to remove any par cles and use rubbing alcohol
or a non
‐
abrasive, non
‐
sudsing cleaner to wipe clean. Use a so , lint free cloth and never use an aggressive solvent such as a
lacquer thinner or acetone which will cause damage to the acrylic.
