Peach PB200-70, Operating Instructions Manual

6 

Safety notices

The following safety notices must be  

followed when using electric devices :

AVOID THE DANGER OF DEATH 

FROM ELECTRIC SHOCK!

   Immediately have a malfunctioning or 

damaged device inspected and repaired 

by an authorised professional or cus-

tomer service.

   Avoid the risk  

of injuries!

   Never touch the heating surface, as it 

becomes very hot.

Description

1

  Document holder

2

  Start button

3

  On / Off  switch

4

  OK light

5

  Power indicator

6

  Binding shaft

7

  Cooling rack

Operation

Switching on the thermal binding machine

   Connect the device to the power supply 

and press the On / Off switch 

3

(Position “I“). The red power indicator 

5

will light up: The device will heat up to 

the operating temperature. The device 

will reach the optimal operating temper-

ature after approx. 3 minutes. The green 

OK light 

4

 will light up and an acoustic 

signal wil sound. 

Binding

   Select the correct Peach thermal portfo-

lio and place the pages to be bound in it 

(see chart).

Number 

of sheets 

(80 g / m

2

)

15 20 30 40 60 80 100 120 150

Portfolio 

thickness 

in mm

1.5 2 3 4 6 8 10 12 15

   Take the portfolio and hit it on the spine 

once or twice.

   Lift the document holder 

1

 all the way 

up.

   Place the prepared thermal portfolio into 

the binding shaft 

6

, until the portfolio 

spine touches the heating surface  

(see Fig. C).

   Now press the Start button 

2

; the OK 

light 

4

 will start flashing. After approx. 

1 minute the OK light 

4

 will briefly ex

-

tinguish and then light steady, acoustic 

signal will sound. The binding process is 

now complete.

   Pull the cooling rack 

7

 all the way out.

   Now place the bound portfolio into the 

cooling rack 

7

 to allow the binding to 

cool. After 60 seconds you have a  

perfect binding.

Switching off the thermal binding machine

   After finishing the respective bindings, 

switch off the device by pressing the 

On / Off  switch 

3

 (Position „

0“).

Cleaning and care

   Always remove the power plug before 

cleaning. Allow the device to cool down 

before cleaning.

   Clean the heating surface and plastic 

parts with a slightly dampened cloth 

and, if necessary, a mild detergent.

English