11
Adjustable legs (Ramp 1)
(c)
Ramp 2 sits over Ramp 1
2
1
Panel
Attachments
(a)
(b)
Jump Stops
FIG.6
FIG.7
5. RAMPS
(a)
Ramp assembly begins with the 1.5 metre non-back ramp with legs
(Ramp 1). Extend legs about 300mm, join to your narrow leadup system
using the panel attachments on the entry of the ramp. (long 10mm or 3/8”
pins may be required)
(b)
Position ramp 2 in line with ramp 1. Lift and securely place the entry
end of ramp 2 over the inverted channel at the exit end of ramp 1
(c)
When the IMMOBILIZER is lined up and correctly positioned, place the
exit end of ramp 2 on the two vertical hooks on the machine (or REAR
ACCESS MODULE if you are using one) so that they are secure in the slots
provided. Rock the ramps to check for stability
6. JUMP STOP
The jump stops bolt to the rails on the ramps to prevent sheep jumping out
or over the one in front. This may extend forward, over the machine to stop
sheep from jumping as they enter. A bend/kink can be placed to point the
jump stop bar right above the machine. Lower the jump stop to reduce the
gap for smaller sheep
Summary of Contents for IMMOBILIZER SHEEP WORKER
Page 2: ......
Page 23: ...23 NOTES...
