Installation and Operating Handbook
Figure 4.2: Configure IP settings window
4.3.1
Webserver
The webpage used to control the PBU2000 unit is essentially split into two screens, Status and Configure. Each
one accessible via the links part way down the screen. The webpage is displayed by entering the PBU2000
unit’s IP address into a normal web browser. Figure 4.3 shows a typical web page view, note this may not
represent this particular unit.
Figure 4.3: Typical webpage status screen
4.3.2
TCP
The PBU2000 unit can be controlled via TCP, this involves sending the normal RS232 / 485 commands to the
unit through a TCP port. The TCP port to be used is set by the user via one of the remote control interfaces.
The remote control protocol that can be used with the unit is shown in section 4.2.
4.3.3
SNMP
The PBU2000 units can be controlled via SNMP via the builtin SNMP (Simple Network Management Protocol)
agent software. It supports SNMP Trap, RFC1155, 1157, 1212, 1213, 1901 & 1906, as well as the Peak
MIBS. The MIBS necessary for this are available from the Peak Communications website. Please refer to the
PeakAgents.MIB file, as this shows which of the MIBS available are used for this PBU2000 unit.
32
Peak Communications Ltd.
PBU2000
Summary of Contents for PBU2000
Page 2: ......
