How to use your laminator
1) Carefully remove the laminator from all of its packaging and place it on a flat, level surface. Make sure you
keep the original packaging somewhere safe (in case this is needed in the future).
2) Unpack the power cable and insert it into the power outlet at the back of laminator. Plug it in to a power
socket. Press the Red POWER switch to turn the laminator on. The red power light will illuminate.
3) Set the HEATER switch to ON.
4) Check that the FWD/REV (Forward and Reverse) switch is set to FWD (See diagram 1)
5) Refer to the temperature chart (as a guide only) and set the laminator to the required temperature.
6) The laminator will now begin to heat. Once it has reached the set temperature, the green READY light will illuminate.
7) Place the document you are laminating inside the pouch, making sure that it is centrally positioned and that a small
border (approx 5mm) is left around the edge. If you are laminating cut-up pieces then you need to use a Lifejacket®.
If you do not have one of these, ask your supplier.
8) Once the document (or small pieces) are positioned in the pouch (and are not overlapping or touching each other),
insert the prepared document into the laminator. Make sure you insert the SEALED EDGE FIRST and do not insert at
an angle. The item will automatically feed through and appear the other end.
!
Do not tug or pull the document as it comes out of the back of the laminator.
9) To turn the laminator off after use, set the HEATER switch to OFF and allow the laminator to still run for 5 minutes
(you will hear the rollers turning). This allows the laminator to cool down and it is then safe to turn the
POWER switch OFF after this time.
It is important that you watch your document as you laminate in case of jamming. If your laminating appears to be
jamming, press the REVERSE switch and gently ease the document back out.
Ready light
Power switch
Temperature
control
Forward/Reverse
switch
Heater/Cold
switch
Parts and Features
Diagram 1
Thank you for purchasing the Peak Pro PP-450. Peak laminators are designed to give you professional,
high quality results, quickly and easily. Please take a few minutes to read through this important document
as any
damage caused to your laminator by user error is not covered under warranty.
x
x
Don’t overlap
Leave a 5mm border
Don’t laminate open
end first
