Document No.:
61 / 91
7.2 Cleaning and maintenance of the probe
Keep the probe clean to ensure that it can operate properly and to extend its service
life.
7.2.1 Cleaning and disinfection steps
(1) Check the probe, for example: Cracking, liquid leakage, etc. If there is obvious
damage, do not continue to use the probe, and immediately contact Suzhou PeakSonic
Medical Technology Co.Ltd.
(2) Wipe the probe with neutral detergent, ethanol (75%) or isopropanol (70%).
7.2.2 Maintenance
For the probe contact surface, carefully protect it from scratch.
(1) Collision and falling are strictly prohibited.
(2) The state-approved medical coupling agent shall be selected as the contact agent
between the probe and the examination part of the patient. If the coupling agent does not
meet the standard, it will damage the probe and irritate the patient's skin.
(3) The window surface of the probe shall be cleaned after being used every time.
7.3 Battery use and maintenance
(1)
A new battery shall be charged and discharged for twice or 3 times to achieve
the best effect.
(2)
The battery can be charged and discharged for hundreds of times. When the
use time of the battery is obviously shortened, the battery shall be replaced in time.
(3)
The use, storage and charging of the battery must be away from fire.
(4) Operations damaging the battery, such as short circuit, dampness, disassembly,
falling and impact shall be prevented.
(5) The battery shall be charged and discharged every two or three months to prevent
battery failure. Note: If the fully-charged battery is not used for a long time, the battery will
