3.3.4.2. Direct Numeric Entry Mode
1)
Press
Key.
ADDRESS DISPLAY goes blank and
Key LED starts blinking.
ADDRESS returns to its original state if no further input is entered during 15 LED blinks.
2)
Enter data with numeric keys.
Correct with
key if necessary.
3)
Complete with
Key.
ADDRESS DISPLAY blinks once indicating the value is stored in the memory. In case the
instrument is in ‘Sequential Recall Mode’, the stored data at the address will appear
immediately (refer to 3.3.5 5).
4)
Single digit addresses (0 to 9) can be entered directly from numeric keys if a numeric value is
entered without first selecting ADDR key.
☞
☞
☞
☞
To Cancel the Procedure , Press
key before
key
3.3.4.3. Address Rotation Function
In case a certain sequence of the instrument settings must be repeated, ‘Address rotation function’ is
helpful. In this mode, a sequence of addresses with data is rotated upon completing ‘END Address’,
the control returns to ‘BEGIN Address’ automatically.
1)
To Store ‘Begin Address’ Press
(SHIFT),
2)
To Store ‘End Address’ Press
(SHIFT) ,
Example 1)
Instrument setting data is stored in address 1 to 15 and to be repeated from 1 to 15
1)
Set desired data (Frequency, Level, Modulation …) into memory address 1 to 15.
2)
Set ‘Address’ to 1 (Press
key)
3)
Set ‘Begin Address’ = 1. (Press
(SHIFT),
).
4)
Set ‘Address’ to 15. (Press
,
,
,
key )
5)
Set ‘End Address’ = 15. (Press
(SHIFT),
).
☞
☞
☞
☞
A. IF it is desired to return to ‘Begin address’ before finishing ‘End address’ while performing
‘Address Rotation function‘, Press
key.
☞
☞
☞
☞
B. To go outside of ‘Begin Address’ and ‘End address’, use direct numeric entry mode to set
new memory address.
☞
☞
☞
☞
C. Address Rotation Function can be cancelled by setting Address
Begin Address
= 00
End Address
= 99
D. Then, all 100 addresses can be accessed and sequenced.
-51-