5.2. Quick Reference of the timed and preset program
The unit can store 10 programs (program number 0-9).
Program 0 is reserved for storing 20 steps (timed subprograms).
Program 1 to 9 is for 9 sets of preset voltage and current.
Please refer to Figure 5.2. for structure.
Figure 5.2. Block Diagram of Timed and Preset Program
6. Operating Instructions
NOTE: This section shows how to perform power supply functions using the front panel.
Operations that you can perform are:
6.1. Setting of Operating Mode
6.1.1. Enable/Disable Output
Page 5
6.1.2. Lock/ Unlock the Keypad and Jog Dial
Page 5
6.1.3. PC Interface RS-232/RS-485 Selection
Page 5
6.1.4. Upper Voltage Limit Setting
Page 5
6.1.5. Output Enable/Disable at Power Up
Page 5
6.2. Basic Operation
6.2.1. Setting of Voltage and Current by Jog Wheel and UP & DOWN Key
Page 5
6.2.2. Setting of Voltage and Current by Key Pad
Page 5
6.3. Using programming features
6.3.1. Timed Programming
Page 5
6.3.2. Running the Timed Program
Page 5
6.3.3. Preset Programming
Page 5
6.3.4. Selecting the Preset
Page 5
-34-
Programming Features
Timed Program
The timed program
can store 20 steps
(timed subprograms)
Preset Program
9 sets of preset
voltage and current
Program 0
Timed Subprogram
Each subprogram is
capable of storing 1 second
to 99 minutes operation
period.
The timed program can run
repeatedly 1 to 256 cycles
or infinite cycles ("0").
Program 1-9
