8.2. Replacing the fuse
Warning!
To avoid electric shock, disconnect the test leads before removing the battery or the fuse. Replace only with
the same type of battery or fuse. Do not remove the top cover. Service should be performed only by qualified
individuals.
Warning!
For protection against fire or other hazard, replace only with fuse of the specified voltage and current ranges.
Follow these steps to replace the fuse.
1. Press ON/OFF to turn off the meter and disconnect the test leads.
2. Remove the battery compartment by unscrewing the screws.
3. Remove the back cover by unscrewing the 6 screws and pulling off the meter´s cover.
4. Remove the blown fuse.
5. Install a new fuse in a fuse compartment.
6. Replace the cover and secure it with the screw.
7. Replace the battery compartment and secure it with the screws.
Warning!
Do not operate your meter until the back cover is in place and fully closed.
All rights, also for translation, reprinting and copy of this manual or parts are reserved.
Reproduction of all kinds (photocopy, microfilm or other) only by written permission of the publisher.
This manual considers the latest technical knowing. Technical changings which are in the interest of
progress reserved.
We herewith confirm, that the units are calibrated by the factory according to the specifications as per the
technical specifications. We recommend to calibrate the unit again, after 1 year.
©
PeakTech
®
06/2010/pt/th
Heinz-Günter Lau GmbH - Kornkamp 32 - DE-22926 Ahrensburg / Germany
+49-(0) 4102-42343/44
+49-(0) 4102-434 16
info@peaktech.de
www.peaktech.de
