Utility
Output mode
Independent mode
Brightness
50 %
Summer
To
Port
Serial
Baud
115200
Data Bits
8
Odd-Even
None
Stop Bits
1
LAN Settings
IP address
192.168.001.099
Subnet Mask
255.255.255.000
Gateway
192.168.001.001
Port
3000
Record
Save
Settings
Location
Internal
Stores
CH1
Car
Record
Location
Internal
Interval
1
Points
1000
Recording
Status
CH1
View
Record
Read
CH1
Location
Internal
Display
Graphic
Program
Data View
Location
Internal
Output Set
Cycle mode
One time
Starting point
1
Endpoint
100
Data Process
Graphics
SET&READ(CH1:VOLT,CURR;CH2:VOLT,CURR)
4.8.3 Update
Press the Utility key and turn the rotary knob until you are in the
Info
menu. Use the
▼ key to switch to the
Update
submenu. Now press the
to load a firmware update from the connected USB stick, if available.
4.9 Port settings
4.9.1 Serial interface
Press the Utility key and turn the knob until you are in the
Port Set
menu. The
Serial
menu is active.
(1) Press the
key to set the value of baud rate. Press the
＜
/
＞
keys to set the desired baud rate between 1200,
2400, 4800, 9600, 19200, 38400, 57600 or 115200. Default is 115200, make sure the baud rate matches the
computer.
(2) Use the
▼ key to activate the
Data Bits
submenu. Press the
＜
/
＞
keys to switch between 6, 7 or 8.
(3) Use the
▼ key to activate the
Odd-Even
submenu. Press the
＜
/
＞
keys to switch between None, Odd or Even.
(4) Use the
▼ key to activate the
Stop Bits
submenu. Press the
＜
/
＞
keys to switch between 1 or 2.
Use the
←
Backspace key to switch back a menu.
-19-
