Tom Tom Setting
Insert the long ends of the Tom Holders into the Tom
Holder Bracket on the Bass Drum as shown (Fig.8) and
tighten the Wing Nuts on the Tom Holder Bracket. Next,
loosen the Key Bolts on the TH-900I Tom Holders using a
Tuning Key or loosen the Wing Nuts on the TH-70I Tom
Holders. Adjust the angle of the Tom Holders so you can
attach the Tom Toms easily then retighten the Key
Bolts/Wing Nuts (Fig.9). Attach the Tom Toms to the other
end of the Tom Holders and tighten the Wing Nuts on the
mounts on the Tom Toms.
Floor Tom Assembly
The Floor Tom is packed with the Shell, Steel Hoops,
Heads and Floor Tom Legs unassembled. Please follow
the assembly instructions below to assemble the Floor
Tom.
2. Line up the ears of the Steel Hoop over the Lugs and
insert the Tension Rods through the ears. Finger tighten
them into all the Lugs on this side of the drum. Using a
Tuning Key, tighten the Tension Rods until secure (Refer
to the “Basic Tuning” section at the end of this manual)
(Fig. 6).
3. Turn the drum over and attach the other Head and Steel
Hoop with the remaining Tension Rods.
4. Attach the Floor Tom Legs to the Floor Tom Leg
Brackets and set the height and angle to your
preference. Tighten the Wing Bolt to secure position
(Fig.6 , 7).
1. Place the Shell on a clean, solid surface with the batter
side facing upwards as shown in Fig.6. Put the Head on
the Shell followed by the Steel Hoop.
Tension Rod
Steel Hoop
Head
Lug
Floor Tom Leg
Wing Bolt
Floor Tom Leg
Bracket
Fig.7
Fig.6
Fig.8
Fig.9
TH-900I
Tom Holder
TH-70I
Tom Holder
Key Bolt
Wing Nut
Note
The Tom Holders are equipped with StopLocks that keep the
drums from slipping or rotating and to memorize position
settings for quick and repeatable set-ups. When the position
of the Tom Toms are set, place each StopLock into the slots
in the Tom Holder Bracket and the mounts on the Tom Toms
to retain these settings (refer to the Set-Up Example
illustration on the first page of this manual).
Note
For Decade Maple, use the Thicker Head for the batter side.
The EXPORT Floor Toms are packed with the Heads and
Hoops assembled. Please proceed to step 4.
StopLock
Key Bolt
Tom Holder Bracket
