Page 45 of 163
you can produce a much wider range of effects than if all your
memories set all the attributes. However, for this to work well you need
to make sure you know what attribute is going to be affected by each
memory, as if you turn on two “colour only” memories then nothing is
going to light up.
10.5
Master faders
In the bottom left hand corner of the console are the Master Faders.
These allow overall intensity control of the whole console.
•
The Add/Flash and Swop masters control the intensity of the Flash
and Swop buttons on the playbacks.
•
The Preset Master controls the overall intensity of any channels
turned on in the Preset faders.
•
The Grand Master controls the intensity of all output from the
console.
10.6
Channel mimics
If you are in normal Run mode, the LEDs on each handle mimic the
intensity of the fixture or dimmer controlled by that handle (i.e. they
are lit if it is turned on).
If you are in Takeover Run mode (or Program mode), you can choose
between “Mimic” mode or “Fixture” mode, where the LEDs show you
which fixtures are selected for manual control.
You select the mode by holding down the Ypl button and pressing
Softkey A. The button shows “Preset LEDs = Fixtures” (or mimics)
depending on the mode. You can also change this mode using the
Graphics Tablet.