c. COMP (compression)
• Type:
The kind of compression applied. To disable
the dynamic processor on the Kit, select “OFF.”
• Compress (compression):
The compression ratio
applied to the signal from the Kit.
• Out Level (output level):
The output level of the
compressor. This is parameter is useful for boosting
the Kit’s signal if its volume has decreased due to the
compression.
d. EQ (equalization)
• LF Gain (low-frequency gain):
The amount of boost
or cut of the low frequency band (as determined by
the LF Freq setting).
• LF Freq (low frequency):
The frequency the LF Gain
will boost or cut.
• HF Gain (high-frequency gain):
The amount of boost
or cut of the high frequency band (as determined by
the HF Freq setting).
• HF Freq (high frequency):
The frequency the HF Gain will boost or cut.
KIT SELECT SETUP
While selecting Kits, you can enter the
KIT CONFIG
Screen
to access a few useful parameters pertaining to the current Kit.
1. Press KIT SELECT
to go to the Main Screen.
2. Use the DEC- / INC+
buttons or VALUE / TEMPO DIAL to select a Kit.
3. Press CURSOR DOWN/KIT CONFIG
to enter the KIT CONFIG Screen for that Kit.
4. Select any of the options
at the bottom of the LCD using the
F-BUTTONS
. Use
CURSOR UP / DOWN
to move through the menu items and
DEC- / INC+ or the VALUE / TEMPO DIAL
to adjust the settings.
• MAIN (F1):
• Kit Level:
The overall volume level for the Kit (00-99)
• Graphic:
The image used to identify the Kit on the main screen.
• MIDI (F2):
• MIDI Chan:
The MIDI channel over which the module will send out
Program Change messages (01-16 or “OFF”). (When set to “OFF,”
the other parameters below will not be displayed.) You will need to
set this properlywhen using the RBM-20 module to
play sounds on another module.
• Ext Prog#:
The Program Change number the module will send out (00-99).
• MSB:
Sets the Most Significant Byte when using sounds on an external
module that requires bank changes (00-127 or “OFF”).
• LSB:
Sets the Least Significant Byte when using sounds on an external
module that requires bank changes (00-127 or “OFF”).
Note:
The RBM-20 will retain any
changes you make to the
Instruments or parameters
as you move between the
various Kits.
16
