MEASURE (F1)
1. Press
UTILITIES
to enter the main
UTILITIES
Menu.
2. Press
CLIK (F1)
to access the click settings. The
first page to appear will be
MEAS (F1)
.
3. Use
CURSOR UP / DOWN
to move through the menu
items and
DEC- / INC+ or the VALUE / TEMPO DIAL
to adjust the settings:
• MeasLvl:
The volume level of the first click beat of every measure (00-99).
(The first beat is often louder than the others to mark the beginning of each bar.)
• MeasSound:
The sound of the first click beat of every measure.
(The first beat is often at a slightly higher pitch than the others to mark the beginning of each bar.)
• BeatLevel:
The volume level of the overall click beat (00-99).
• BeatSound:
The sound of the click beat.
SUBDIVISION (F2)
This page lets you adjust settings for the subdivision click.
This is similar to the regular click but while the regular
click sounds every beat, the subdivision click
sounds during smaller intervals of each measure.
1. Press
UTILITIES
to enter the main UTILITIES Menu.
2. Press
CLIK (F1)
to access the click settings.
3. Press
SUBD (F2)
to access the subdivision click
settings.
4. Use
CURSOR UP / DOWN
to move through the menu items and
DEC- / INC+ or the VALUE
DIAL
to adjust the settings:
• SubDvsn:
The length of each subdivision. The range includes OFF, 1/4, 1/8, 1/16,1/32 and 1/64 notes
– both regular and triplet. (Example: If the regular click is set to a 4/4 time signature and “
SubDvsn
”
is set to “1/8,” you will hear the regular click on every 1/4 note as well as the subdivision click on every 1/8 note.)
• SubDLvl:
The volume level of the subdivision click sound (00-99). We recommend keeping this volume
relatively low so it is not confused with the regular click sound.
• SubDSnd:
The sound of the subdivision click.
TAP TEMPO (F3)
This page lets you adjust settings for the
TAP TEMPO
button and
the tempo LED.
1. Press
UTILITIES
to enter the main
UTILITIES
Menu.
2. Press
CLIK (F1)
to access the click settings.
3. Press
TAP (F3)
to access the Tap Tempo settings.
4. Use
CURSOR UP / DOWN
to move through the menu items
and
DEC- / INC+ or the VALUE / TEMPO DIAL
to adjust the settings:
• Tempo LED:
This setting lets you control when the tempo LED will be seen. When set to “ON,”
the tempo LED will flash all the time. When set to
“PAT ONLY,”
the tempo LED will only flash
when a Sequence is playing. When set to “
OFF
,” the tempo LED will never be seen.
• Tap Tempo:
Enables or disables the TAP TEMPO button. Disabling it may be useful if you do
not want to make any unintentional changes to a Sequence’s tempo.
CLICK ROUTING (F4)
This page lets you select the module’s outputs through which the
click sounds will be sent. This can be useful for maintaining
two separate mixes. (For instance, you may want to have a
monitor mix with the click sent to you through the
AUX
OUT
, but you want to have a separate mix without the click
for the house PA system.)
1. Press
UTILITIES
to enter the main
UTILITIES
Menu.
2. Press
CLIK (F1)
to access the click settings.
29
