10
EFFEKTEINSCHLEIFWEG
Um die Flexibilität des Verstärkers noch zu erhöhen können hier Effekte eingeschliffen werden. Der Send
gibt über die 6,3mm Klinkenbuchse ein Signal raus, welches über 6,3mm Klinkenbuchse des Return wieder
zum Verstärker zurück geführt wird.
LAUTSPRECHER IMPEDANZWAHLSCHALTER
Hier kann die Impedanz, der zusätzlich angeschlossenen Lautsprecherbox(en), eingestellt werden. Bei
einem Röhrenverstärker ist zwingend darauf zu achten, dass die Impedanz richtig angepasst wird um
Schaden zu vermeiden. Werden zwei Boxen mit gleicher Impedanz verwendet, muss der Schalter auf
die Hälfte des Werts der einzelnen Boxen eingestellt werden (Beispiel: Für zwei 16-Ohm-Boxen wird der
Schalter auf 8 Ohm gestellt, für zwei 8-Ohm-Boxen wird er auf 4 Ohm gestellt).
LAUTSPRECHERAUSGÄNGE
An diese beiden, parallel geschalteten, 6,3mm Klinkenbuchsen werden die Lautsprecherbox(en)
angeschlossen. Die Mindestimpedanz beträgt 4 Ohm. Der Impedanzwahlschalter (24) muss stets auf die
richtige Gesamtimpedanz eingestellt werden. Niemals den Verstärker ohne Lautsprecher benutzen!
MSDI™ – “MICROPHONE SIMULATED DIRECT INTERFACE”
Peavey`s patentierte MSDI™ Schaltung simuliert, über den symetrischen XLR-Ausgang,
eine mit Mikrofon abgenommene 4x12" Box. Egal in welcher Situation, diese überzeugende Geheimwaffe
liefert immer einen konstanten Sound, frei von jeglichen Störgeräuschen und immer in voller Dynamik.
Ideal für den Live- und Studiobetrieb.
GROUND LIFT
Dieser Schalter eliminiert evt. auftretende Brummgeräusche, die über eine gemeinsame
Masseverbindung zum Mischpult auftreten können.
FUßSCHALTER
6,3mm Stereo Klinkeneingangsbuchse – hier wird der (optionale) Fußschalter eingestöpselt.
NETZSICHERUNG
Die Netzsicherung befindet sich unter der Kappe des Sicherungshalters. Sollte die Sicherung auslösen,
ist es unbedingt erforderlich, sie durch eine gleichwertige Sicherung zu ersetzen, da das Gerät sonst
ernstlichen Schaden nehmen kann und der Garantieanspruch erlischt. Falls die Sicherung wiederholt
auslöst, sollte das Gerät unbedingt durch einen qualifizierten Service-Techniker überprüfen werden.
WARNUNG: DIE NETZSICHERUNG AUSSCHLIESSLICH NUR BEI GEZOGENEM NETZSTECKER ERSETZEN!
IEC - NETZANSCHLUSS
An diese Normbuchse wird das im Lieferumfang enthaltene, den Spannungswerten des Landes
entsprechende Netzkabel angeschlossen. Bitte stets zuerst die verstärkerseitige Verbindung herstellen,
bevor der Netzstecker an die geeigneten Netzsteckdose angeschlossen wird.
LEBENSGEFAHR!
Niemals den ehen, da dieser der Sicherheit dient.
STROMKABEL FÜR DIE VERWENDUNG INNERHALB DER USA
Das mitgelieferte Stromkabel ist ein dreiadriges Hochleistungskabel mit einem konventionellen 120V
AC Stecker mit Erdungspol. Wenn der Anschluss keinen Erdungspol besitzt, sollte ein geeigneter
Erdungsadapter verwendet werden, so dass das dritte Kabel ordnungsgemäß geerdet wird.
Entfernen Sie niemals den Erdungspol eines Gerätes. Er dient Ihrer Sicherheit.
NOTE: FOR UK ONLY
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must
be connected to the terminal that is marked by the letter E, the Earth symbol, colored green, or colored
green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with
the letter N or the color black. (3) The wire that is colored brown must be connected to the terminal that is
marked with the letter L or the color red.
Bedienfeld Rückseite
23
28
29
24
25
26
27
30
23
25
24
26
27
28
29
30
Summary of Contents for 6505+ 112 Combo
