16
Lift Handle Installation
NOTE:
Before continuing the Lift Handle installation,
have someone assist you in turning the Box Assembly
upside down. Insert (1) 3/8”-16 x 2” HHCS P#(K1208)
into the Lift Handle P#(A0897), and secure with (1) 3/8”-
16 Flange Nut P#(K1215). Thread the flange nut onto
the bolt upside down, as shown in Figure A. Do not
tighten the nut fully at this time.
Slide the Lift Handle through the slot on the Handle
Mount Bracket. Insert the Lift Handle into the Box Frame
as shown in Figure B, and secure using (1) 3/8”-16
Flange Nut P#(K1215) on the inside of the Box as shown
in Figure C. Now test the movement of the handle. It
should have full-range of movement in the slot. If the
handle does not have full-range of movement, adjust the
3/8”-16 Flange Nut from step A. Once achieved, tighten
the fasteners.
Fasten the Ball Joint P#(K1442) to the end of the Latch
Rod P#(A2107). Tighten the Ball Joint to approximately
half-way down the threads on the Latch Rod. Attach the
Ball Joint to the Latch Hook as shown in Figure D, using
(1) 5/16”-24 Hex Nut P#(K1444) and (1) 5/16” Lock
Washer P#(K0043).
Attach the other end of the Latch Rod to the Lift Handle,
as shown in Figure E. Attach one end of the Spring
P#(J0176) to the Lift Handle and the other end of the
Spring to the Handle Mount Bracket as shown in Figure
F. Adjust the Ball Joint up or down on the Latch Rod
threads until the Latch Hook closes completely. After
adjusting the Latch Hook, secure the Latch Rod to the
Lift Handle using (1) Cotter Pin P#(K0094).
Insert (1) 3/8”-16 x 2”
HHCS Into The Lift Handle
Secure With
(1) 3/8”-16 Flange Nut
Slide Lift Handle Through
Handle Mount Bracket And
Fasten To Box Frame
Use (1) 3/8”-16 Flange Nut
On The Inside Of The
Grass Container
(1) 5/16”-24 Hex Nut
(1) 5/16” Lock Washer
Latch Hook
Ball Joint
Attach Latch Rod
To Lift handle
Secure With
(1) Cotter Pin
Attach Spring To
Lift Handle And To
Handle Mount Bracket
Figure A
Figure B
Figure C
Figure E
Figure F
Figure D
Latch Rod
Summary of Contents for 23651201
