2-19 Hose Clamp Preparation
Note:
To prevent injury, wear safety gear when
cutting or grinding hose clamps.
The hose clamps P#(J1000), provided with your
collection system, will fit hose sizes 6” through 9”. The
excess should be cut from the clamp prior to installing
the hoses. Follow the steps listed to properly install the
hose clamps to your collection system.
Step 1:
Measure from hose clamp’s fastening end (end
with tension screw) to the dimension specified for your
hose diameter and mark the clamp for cutting. Refer to
Figure 2-19a.
Step 2:
See note on Caution above! Cut the hose clamp
at mark determined from Step 1. It is recommended to
use heavy-duty snips or a cutting wheel. Refer to Figure
2-19b and 2-19c.
Step 3:
Using a flat file or disc grinder, remove sharp
edges from clamp cut in Step 2. Refer to Figure 2-19d.
Step 4:
Loop previously cut hose clamp end under and
through the clamp’s tension screw. Next, slide one
finishing cap P#(V0040) over cut end. Refer to Figure 2-
19-e.
Step 5:
To clamp hose, first slide completed clamp
assembly over hose end. Next, hold tension screw up
while pulling clamp end to pre-tighten. Then, fold
tension screw down and tighten using 5/16” socket or
flat-head screw driver. See Figure 2-19f.
!
CAUTION
6” Hose - Cut to 23”
7” Hose - Cut to 26”
8” Hose - Cut to 29”
9” Hose - Cut to 32”
Tension
Screw
Mark
Clamp
Here
Figure 2-19a
Figure 2-19b
Figure 2-19c
Or Use Cutting Wheel
Use Heavy-Duty Snips
Cut At
Mark
Cut At
Mark
Figure 2-19d
Remove Sharp Edge
From Hose Clamp
Figure 2-19e
Attach Finishing Cap
To Hose Clamp End
Figure 2-19f
Attach Hose
Tighten Clamp
15
Summary of Contents for 37721231
