Peco 52020901, Operator'S Manual

12

3. Make sure all shields are in place and in good 
    condition. Repair or replace any missing or damaged 
    shields.

4. Perform lubrication per paragraph 4-2.

5. Listen for abnormal sounds, which might indicate 
    loose parts, damaged bearings, or other damage. 
    Correct any deficiency before continuing operation.

6. With the engine off, engage the blower assembly. 
    Check the belt tension and inspect the pulley belt for 
    cracks or tears.

7. Check for wear or deterioration of the upper or lower 
    hoses. If there are any portions of the hose that have 
    been torn or worn through, replace immediately.

After Each Use:

1. Clean all debris from machine especially from the 
    container, underneath the belt shields, and safety 
    decals. Replace any missing or illegible decals.

2. Inspect the unit for worn or damaged components. 
    Repair or replace before the next use. Any 
    replacement component installed during repair shall 
    include the component’s current safety decal specified 
    by the manufacturers to be affixed to the component.

3. Check belt for proper tension.

WRITE THE MODEL AND

SERIAL NUMBER IN THE

BOX TO THE LEFT 

FOR FUTURE REFERENCE.

4-2 Lubrication

NOTE: 

Use only white lithium based grease for 

lubrication of the shaft on the blower assembly.

1. On initial use: Grease the fitting on the blower shaft.

2. Every 25 hours of use: Re-grease the grease fitting.

3. Every 200 hours of use: Check oil levels in gear box.
    Oil in gear box should cover the gears. If not, fill using 
    an EP90 weight oil. 6oz. will fill the gear box from 
    empty.

SECTION V

PARTS AND SERVICE

5-1 Parts And Service Information

Collection system owners should record the name and 
telephone number of their Service Center. Your Service 
Center will be happy to supply replacement parts, 
accessories, and do any service or repairs to your 
collection system. If for any reason your Service Center 
is unable to service your collection system or supply 
replacement parts, contact PECO Inc. and include the 
following information on the chart below. 

THE SERIAL NUMBER PLATE

IS LOCATED ON THE PTO 

ASSEMBLY P#(A1815)

Unit Model Number:

  _____________________________

Unit Engine Size:

_____________________________

Unit Serial Number:

  _____________________________

Date of purchase: 

_____/_____/_________

Dealer/Distributor Name:

  ________________________________________

Address: 

 _____________________________________ 

State:

  __________   Zip:__________

Phone Number:

  ____________________________