Page 14
1. Remove the restraint
from the box.
2. Place the restraint
upside down, then
cut and remove the
Support Harness ties
(See Arrows - Figure
A).
3. Remove the rubber
bands from the Sup-
port Harness pull
straps (See Arrows -
Figure B).
4. Place the restraint
right side up in the
vehicle seat (Figure
C).
5. Press down on one
of the Support Har-
ness adjuster buttons
while pulling up on
the corresponding
vertical strap to ex-
tend it as much as
possible (Figure D).
6. Repeat Step 5 until
the strap is com-
pletely extended.
A
B
D
Installation of Restraint
C
Page 39
Installation of Occupant with Hip Strap, Cont.
4. Tighten the strap by pulling
up on it’s free end (Figure
E).
5. Repeat Steps 3 and 4 for the
other side of the Hip Strap.
6. Figure F shows the occupant
with the Hip Strap installed.
F
E