Page 34
Installation of Pommel
1. From the bottom of the
restraint, insert the
looped end of the pommel
attachment strap through
the slot shown in Figure
A.
2. Pull the attachment strap
through to the top of the
restraint until both loops
(See Arrows) are visible
(Figure B).
3. Inert pommel flap into
the loop in the pommel
attachment strap (Figures
C) and velcro the flap
back to the pommel.
(Figure D).
A
B
D
C
Page 19
Installation of Tether Extension Assembly, Continued
4. Grasp the loose end
of the tether exten-
sion assembly and
pull towards the
Support Harness
(Figure E) until the
Support Harness is
taut (Figure F).
NOTE: Spacer Bar
must be parallel to
vehicle floor (Figure
E). If not parallel,
repeat Steps 5 - 7 on
Pages 14 and 15; and
Steps 15 and 16 on
Page 17.
Caution: Verify that
Spacer Bar is posi-
tioned behind head
rest (or seat back if
there is no head
rest).
E
F