4 of 7
ISSUED: 01-15-11 SHEET #: 120-9104-2 06-13-11
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112
In-wall box (
A
) can be installed between two studs
16" off center. Use a stud fi nder to locate the
edges of the studs. Use of an edge-to-edge stud
fi nder is highly recommended. Based on its edges,
draw two vertical lines down the inside edges of
the studs. Mark desired center of in-wall box. Draw
a horizontal line 4-15/16" (125mm) above desired
center of in-wall box. Draw a second horizontal
line 9-3/4" (247mm) below this line to outline wall
opening between inside edges of studs. Remove
drywall inside cut outline.
Insert in-wall box (
A
) into wall until fl ange is fl ush
with drywall as shown in fi g. 1.1.
Level in-wall box, and mark center of the four
mounting holes. Make sure that the mounting
holes are on stud centerlines. Drill four 3/16"
(5mm) dia. holes 1-1/2" (38mm) deep. Make sure
in-wall box is level, and secure it using four wood
screws (
B
) as shown in fi g. 1.2.
Installation to Wood Stud Wall
1
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that in-wall box is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations.
WARNING
fi g. 1.1
A
FLANGE
B
fi g. 1.2
9-3/4"
(247mm)
13-1/8"
(333mm)
STUDS
TOP LINE OF CUT
OUTLINE
CENTER OF
IN-WALL BOX
4-15/16"
(125mm)
