2 of 6
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112
Note:
Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud fi nder is highly recommended.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
WALL CONSTRUCTION
HARDWARE REQUIRED
•
Wood
Stud Included
•
Metal Stud
Do not attach except with Peerless accessory kit ACC415;
Contact Customer Service for Peerless accessory kit ACC415
•
Brick
Contact
Qualifi
ed
Professional
•
Drywall
Do not attach except with Peerless accessory kit ACC415;
Contact Customer Service for Peerless accessory kit ACC415
•
Other or unsure?
Contact Qualifi ed Professional
WARNING
Table of Contents
Parts List................................................................................................................................................................................. 3
Installation to Wood Wall ........................................................................................................................................................ 4
Cable Management ................................................................................................................................................................ 5
Tools Needed for Assembly
• stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
• 3/16" (5mm) drill bit for wood studs
• level
