ISSUED: 09-30-02 SHEET #: 090-9085-6 07-23-13
2 of 5
G
DESKTOP
C
C
DESKTOP
H
I
K
Insert telescopic pedestal (
A
) into mounting base (
C
).
Tighten set screws where shown with 3 mm allen wrench (
N
).
Mark hole on desktop for positioning mount.
Drill one 1/2" dia. hole through desktop. Attach
mounting base (
C
) to desktop using hex bolt (
H
),
pressure plate (
K
), and hex nut (
I
). Tighten nut
using proper sized wrench.
Important!
Mount is to be installed onto desktops
3/4" to 1-5/8" thick only! For thicker mounting
surfaces, you may have to provide your own
hardware.
There are two methods of installation.
Follow step 1 for installation using hex bolt and pressure plate or
step 2 using four wood screws.
Use four holes on mounting base (
C
) to mark holes
on desktop for positioning mount. Drill four 3/16"
dia. holes through desktop. Attach mounting base
(
C
) to desktop using four wood screws (
G
).
SET SCREWS
A
C
• Mount must be installed on wood and/or wood composition surfaces of at least 3/4" thick. However, the installer
must ensure that the mounting surface will safely hold the combined weight of the mount and the screen. See other
mounting requirements below.
CAUTION
