12
ISSUED: 2012-10-11 SHEET #: 180-9041-2 2012-05-31
If your power source is located outside of the enclosure (
A
), route the power cord from the
power strip through the hole in the top or bottom of enclosure (
A
). Push the power cord through
the bottom of the cable bushing (
J
). Push cable bushing (
J
) into hole in the enclosure (
A
). Plug
into power source. If your power source is located inside the enclosure, push
fi
nishing cap (
K
)
into top and bottom holes in the enclosure (
A
).
D
A
J
K
A
A
Install power strip (
D
) onto mounting screws inside of enclosure assembly (
A
).
2
3
Summary of Contents for WL-AU-AVWS
Page 2: ......
